Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Different approach

I'm just wondering is there a way to control Wago in Calaos through ModBus without using Yours Wago program ?

I would like to use more functions like Oscat.

Best Regards,

Modbus is already used for all wago PLCs, but the calaos program is needed because Modbus is not enough for calaos. The program also implements event based input changes as well as heartbeat or DALI.
Calaos Core Dev.
Calaos git sur NUC NUC5PPYH | Wago 750-849 | DALI RGB | Sondes NTC sur 750-464 | Sondes 1Wire DS18B20 avec adaptateur USB DS9490R | Nodes MySensors avec gateway USB | Ecran tactile ELO avec adaptateur USB/RS232 | Squeezebox Duet et Radio | Logitech Harmony Ultimate | Ampli Pioneer VSX921
Thanks for answer,

I need to look more deep in to Yours Wago program,

Best Regards,

Forum Jump:

Users browsing this thread: 1 Guest(s)